Use wood glue and 1 1/4″ screws to secure together.Line up the center of the dividers with the center of the stall supports.Mark the centers of the stall supports (1 1/8″) and the centers of the dividers (3/8″). Make sure the side pieces are mirror images of each other.Īttach the 3/4″ x 3/4″ side support piece to the inside face of the side piece, make the bottoms flush. If you want your screw heads flush with the surface, drill countersinks. On the side pieces, cut a dog ear (45 deg miter) on the top front corner at 11 3/4″ up from the bottom.ĭrill pilot holes in the 2 sides, back, lower shelf, stall supports and side supports. (I used a miter saw to make the cuts.) On the top shelf, cut the width down to 8 1/2″.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |